EarthQuaker Devices Gary Automatic Pulse Width Modulation Fuzz/Overdrive Pedal

คุณสมบัติสินค้า:

หมวดหมู่ : PEDALS & PEDALBOARDS ELECTRIC GUITAR PEDALS

แบรนด์ : EarthQuaker

Share

EarthQuaker Devices Gary Product Specifications

EarthQuaker Devices Gary Product Specifications

Fuzz Section (Right Brain)

Garys right brain consists of a dynamic and destructive fuzz that is both domineering and interactive. It features an envelope-controlled variable pulse width and turns the signal into a square wave. The Yes! control adjusts envelope sensitivity, affecting sustain and tone response. As sensitivity increases, the tone becomes nasal and biting until it disappears entirely, creating a unique pulsing effect.

Overdrive Section (Left Brain)

Garys left brain offers a simple and natural-sounding overdrive based on the green channel of the Gray Channel pedal. The Go control adjusts gain, from a clean boost to full-bodied distortion. Thats It serves as the master volume for the overdrive section.

Controls

  • Go: Gain control for the overdrive.
  • Thats It: Master volume for the overdrive.
  • Yes!: Adjusts envelope sensitivity for the fuzz.
  • Oosh: Master volume for the fuzz.
  • Left Footswitch: Activates overdrive.
  • Right Footswitch: Activates fuzz.

Technical Specifications

  • Dimensions: 4.75 x 2.50 x 2.25 in. (121 x 64 x 57 mm) with knobs
  • Current Draw: 20 mA

Fuzz Section

  • Input Impedance: 1 MΩ
  • Output Impedance: <1 kΩ

Overdrive Section

  • Input Impedance: 500 kΩ
  • Output Impedance: <1 kΩ

TRS Expression Pedal Wiring

  • Tip: Wiper
  • Ring: +3.3V
  • Sleeve: Ground

Flexi-Switch® Technology

This device features Flexi-Switch® Technology, a relay-based true bypass system allowing both momentary and latching operation:

  • Latching Mode: Tap the footswitch once to activate the effect and tap again to bypass.
  • Momentary Mode: Hold the footswitch to engage the effect and release to bypass.

Note: Power is required for relay-based switching.

Power Requirements

This device operates on a standard 9V DC power supply with a 2.1mm center-negative barrel. Using isolated, pedal-specific power supplies is recommended to avoid noise issues. Do not use higher voltages!

เว็บไซต์นี้มีการใช้งานคุกกี้ เพื่อเพิ่มประสิทธิภาพและประสบการณ์ที่ดีในการใช้งานเว็บไซต์ของท่าน ท่านสามารถอ่านรายละเอียดเพิ่มเติมได้ที่ นโยบายความเป็นส่วนตัว  และ  นโยบายคุกกี้